India has inaugurated the world’s first plant that makes hydrogen using nuclear reactor heat instead of electricity. Built at Kalpakkam, the copper-chlorine cycle points to a cleaner, round-the-clock route to green hydrogen.
On a stretch of the Tamil Nadu coast where the sea meets some of the country’s most guarded science, a reactor that has hummed for four decades has just done something no reactor anywhere else in the world has done before. The nuclear reactor in India has used its own heat, not electricity, to pull hydrogen out of water.
That single distinction is the reason scientists are calling this a milestone.
On June 26, 2026, the Department of Atomic Energy inaugurated what it describes as the world’s first hydrogen production facility driven by the heat of a nuclear reactor rather than by electricity. It sits at the Indira Gandhi Centre for Atomic Research in Kalpakkam.
The plant is small, but its significance is not.
WHAT DID INDIA JUST ACHIEVE AT KALPAKKAM?
India built and switched on a working plant that turns water into hydrogen, a clean fuel that burns to give only water and no carbon dioxide, using heat tapped directly from a nuclear reactor.
The facility is a technology demonstrator, which means a pilot built to prove an idea works in the real world rather than to make fuel by the tonne. Its job is not output. Its job is proof.
WHY MAKE HYDROGEN FROM HEAT INSTEAD OF ELECTRICITY?
Most clean hydrogen today is made by electrolysis, where electricity is passed through water to split it into hydrogen and oxygen. It works, but it is hungry for power and expensive. Kalpakkam takes a different road entirely.
The plant uses the copper-chlorine cycle, which belongs to a family called thermochemical water splitting. Here, heat, rather than electricity, does most of the work of pulling water apart. Water is stubborn.
Split it head on, and you need either a huge jolt of electricity or a furnace far hotter than 800 degrees Celsius.
So the cycle does not attack the water directly. It uses copper and chlorine compounds as reusable helpers, middlemen that break one impossibly hard task into a handful of gentler ones.
The water reacts with a copper compound first, and through a short sequence of milder reactions, the hydrogen peels away at one stage and the oxygen at another.
Here is the elegant part. By the end of the sequence, the copper and chlorine are handed back exactly as they began, ready to seize the next drop of water. They are never used up.
Picture a step stool that lets you lift a heavy box onto a high shelf in easy stages, then stays put for next time. The copper and chlorine are that stool for water.
Only water is truly consumed, hydrogen and oxygen come out, and a small electrical step remains, though it sips far less power than ordinary electrolysis.
WHY IS THE COPPER CHLORINE CYCLE SO SUITED TO A REACTOR?
What makes this cycle special is its temper. According to published research on the process, the cycle runs at roughly 450 to 550 degrees Celsius, while many rival thermochemical cycles demand a furious 800 degrees or more.
That gentler temperature is exactly what a nuclear reactor can comfortably supply.
